Here is a fun craft for Valentine’s Day that can be reused through the years!

You will need the following supplies for this heart shaped wreath form:

• 1 wire coat hanger
• 1 small pipe insulator (with adhesive if possible, that is what the yellow strip is in the photo). Available in the plumbing section.
• Duct tape
• Scissors
• Pilers

How To Make a Heart-Shaped Wreath Form

1. Bend the wire coat hanger into a heart shape. Done mostly with your hands but having a pair of pliers to bend the neck down and then back up makes it easier. Use the pliers to bend the hook into a circle for hanging the finished wreath.
2. Cut the pipe insulator in half. Wrap half on the first side of the hanger, with the seam to the outside. Remove the adhesive strip and stick the seam together. Do the same to the other side.
3. Using the scissors cut a 45 degree angle from the bottom edge of each side of the pipe insulator. This will allow the foam to fit together to make the point of the heart.
4. Wrap the top and bottom of the heart with a few strips of duct tape to hold the pieces together.

DIY craft sourced from: http://www.fynesdesigns.com/make-heart-shaped-wreath-form/